Perkins Builder Brothers

On this episode we take a trip to the local building department to pull the building permit, check out the building site, and figure out the placement/layout of the home!

On this episode we Begin the actual construction by digging the footings! You never know what you’re going to run into up in the mountains and on this one we run into a lot of rock!

On this episode We finish digging the footings and set the great steaks and reinforcing steel in preparation for pouring concrete! We also prep for utilities by trenching for the waterline and putting a sleeve under the footing.

On this episode We pour the concrete footings for our project! This pose is its own challenges due to the rugged terrain getting the concrete pump and the concrete truck to the job! Learn tons of great tips for pouring good friends for your project!

On this episode build a block (cmu) crawl space foundation for our mountain cabin! Learn all kinds of pro tips on laying block corners and straight runs as well as about layout for foundations!

On this episode We finish building the foundation by installing the anchor bolts, doing a coat of Stucco for aesthetics, and backfilling the foundation. This includes smoothing up to make sure that the crawlspace is suitable for mechanical contractors to get around easily and ensure there a vapor barrier will a nice and flat!

On this episode we frame the lower level floor system! This includes installing the support posts, girders, and plates that attach the woodwork to the foundation!

On this episode we Put down the Advantech subfloor on the first floor of our cabin!!

On this episode we start framing the walls on the main level of our cabin! Learn all kinds of pro tips about building and construction including layout, nail patterns, and general wall construction basics.

On this episode We finish framing the exterior walls on the main floor of our mountain cabin! We also try out Zip System liquid flashing on our windowsills, and give teach some of the most critical fundamentals for building good walls!

On this episode we frame the interior walls of the main living space of the cabin and then go up another floor! This includes great tips for building girders, walls and floor systems!

On this episode we Put down the loft subfloor and then build out the high wall sections for the vaulted living area! But… unfortunately we have to remodel some of our framing immediately.

On this episode we finish framing the interior walls and battle the elements to get it done!

On this episode We frame the front living room wall one piece at a time and prep all of the upper floor walls for the ceiling system. We also double check our structural load points and add squash blocks where needed, to carry point loads to the footing.

On this episode We start in on framing the roof on the main wing of our cabin. To do this we have decided to stick frame our own Trusses instead of ordering them prefab. This gives us flexibility to make changes on the fly and not have to rely on a crane getting up the mountain to build a roof system! In this case we have Sized the rafters and ceiling joists to carry their loads without intermediate webbing instead of having center members with webbing.

On this episode we get the main part our cabin dried in! Learn tons of tips on framing roofs and overhangs!

On this episode we Build the ceiling and roof structure over the owners bedroom suite off the backside of the cabin! We also talk about what it takes to build a house!

On this episode we build the decks and covered porches from the ground up! Learn tons of great tips on how to build a great deck!

On this episode we build the porch roofs as well as discuss roof design aesthetics and functionality! It’s another great day building a cabin in the mountains of western North Carolina!

On this episode we Finish building the more complicated part of our porch roofs And give a quick lesson on how to build a valley intersection between two rooflines!

On this episode we do the rough framing in our stairwell of our mountain cabin! Lots of good explanations on how to cut stringers and build code passing comfortable stairs!

On this episode we Build the stairwell wall, install the permanent post for the loft, do the fireplace framing and draft stops, install the deck rail post and blocking for our Trex decking, as well as installing all of the decking!

On this episode we do some REAL contractor stuff… we go through the whole cabin and do the electrical layout! Also, we learn lots of home wiring tricks and tips from the crew working there. It’s another fun and informative day on the mountain!!

On this episode we Finally get started with the outside finish of our cabin using Lp Smartside expert finish siding! As always it’s a fun time on the mountain with lots of good information about how to build a house!

On this episode we tackle some of the more difficult areas of the finished facia, as well as some other Miscellaneous tasks that need to be done before we can do drywall! Also get some great tips on how to install doors that won’t leak and run your floors later!

On this episode we finally Get a few of the windows for our project! This frees us up to start moving around the house and doing siding in the areas we have windows. Jaime also breaks out some very cool old-school woodworking tricks and we talk about window installation!

On this episode we will get going with the soffit installation as well as the firebox, which has its own issues due to supply chain problems as well. As always it’s a great day up on the mountain building with the Perkins crew so check it out!

This video we will be finishing up our soffits and ceiling everything up with caulk before we tear down the scaffolding. Lots of great pro tips on how to measure and install material accurately the first time!

This video we will be Installing the porch ceilings as well as more siding on our mountian cabin. We also give our new table saw a review after using it for a week on the job and check out some technical flashing details in preparation for the roof installation.

In this video we get going with the board and batten siding and explain some more cool flashing details for roof intersections! We also check out some new tools as well as have a few scary moments with a nearby wildfire!

In this video We get into all the details of installing board and batten siding as well as go through the house and make final adjustments to electrical box locations in preparation for the insulation.

In this video we show some easy and accurate ways to mark angled cuts on sheet goods and lap siding for a PREMO looking job. Erik’s son also gets to come out to the job on spring break and start learning about how to build.

In this video we install the tongue and groove ceilings on the porches.. which we previously had installed something else without looking closely at our spec sheet on the contract.

In this video we learn all about roofing as we get going with the architectural shingle roof surface on our cabin!

In this video we learn all about the details of shingling a roof including step flashing installation, ridge caps and ridge vents, valley details, and more about how shingles are made to last and keep a home water tight!

In this episode we build the front porch steps and explain many of the common mistakes that could be made while figuring stringers. We also install the woodwork for the Cable rail system on the two large decks.

In this episode we finally get back to work at our mountain cabin project! We start by prepping for paint on the walls and ceilings, which includes (but is not limited to) cleaning, priming, and sanding the walls surfaces as well as masking off everything we don't want to get painted.

In this episode We get to hang out with Tyler and Adam from e-rigging.com and install A different type of cable rails on the mountain cabin porches. Learn all about how to install the Revo system, as well as tons of general knowledge about Building and Railings.

In this episode We continue to make good process on our mountain cabin bill! We receive and check out the cabinetry, vanities and built-ins that were custom made by Cole Hill custom cabinets and get the first coat of paint on the walls!

In this episode we prep the subfloor for tile with backer board, measure up and order interior doors, and work with the electricians as they begin the trim-out process. As always its a great day working up on the mountain with the Perkins Crew!

We get cracking on the bathroom tile in the three bathrooms… and knock it out all in one day! Learn some great tips for tiling and As always its a great day working up on the mountain with the Perkins Crew!

In this episode we have to immediately do some remodel work to the bathroom tile before grouting. Then we go on the hunt for the perfect hearth stones for the fireplace down at the local rock yard. After "dusting" our visitor to the job, we cut and install the hearth stone. As always we show you how it REALLY happens, including our own mess-ups!

In this episode we form up and make a concrete lintel and complete the stonework on the fireplace! We also get going with the engineered wood flooring... as always its a great day working up on the mountain with the Perkins Crew!

In this episode we finish the upper portion of the fireplace, continue with the engineered floor installation, and get to finally turn on the POWER... as always its a great day working up on the mountain with the Perkins Crew!

In this episode we Continue grinding away on the flooring installation but make a huge progress on the overall completion by getting all of the cabinetry to the job site and start with the cabinetry install!

In this episode we make more progress installing the kitchen cabinetry and check out some cool specialty tools!

In this episode we install the crown moulding and kitchen island... including an amazing wooden bar top! Arlo also tests his trust in Jaime's nail gun skills while holding a workpiece for him!

In this episode we finally get the remainder of our window package and begin installing them! As always its a great time working up on the mountain with the Perkins Crew!

In this episode we check out a couple of pro tips for working on shingled roofs with jaime, install the last two windows, and do the finished grading so we can get gravel on the parking area!

In this exciting episode we continue to "keep it real" by documenting ALL of the process of building a house start to finish... including hauling trim boards, nailing siding, and caulking!

In this exciting episode we build and install all of the interior window casings!

In this exciting episode we Stain, finish and install the interior doors… which does not go as smoothly as we had hoped! We also receive our final window that was missing on our first order and have some surprises there as well!

In this exciting episode we build the jams for the bi-fold closet doors and install them, as well as get some cool pro tips from JONO on installing stained baseboard! We also finally try to deal with the beeping smoke detectors before we lose it!

In this exciting episode we install the door knobs, shingle the porch roof, wrestle baseboards, and get some great advice from Jason!

In this episode We continue to make good process on our mountain cabin build! Jaime is at the shop with Arlo working on the loft railings, while Erik, Jason and Ray battle some small, but tedious, tasks at the job.

In this episode we see if the loft railings made offsite fit or not and We also give you an honest review of almost every brand of cordless circular saw and what we think of them.

In this episode we continue to tackle the many small and large tasks to get this project 100% punched out... today we fab up metal handrails for the stairwell, as well as building crawl space doors out of aluminum and mounting floating shelves in the kitchen!

In this episode we finally wrap it up and pack out of the mountain cabin job!