The Ben Heck Show

Super Glue Gun: Design with Fusion 360 (11) (8x3)

:

Ben and Karen talk through some of the suggestions from elemnt14 Community members for the super glue gun build, before getting on with the motor placement for the final design. However, after some 'Hand Polling' Ben is concerned that the handle might end up too thick if the motor is placed at the side or near the handle. Luckily, Karen has a proposed design change that could make all of Ben's headaches go away...for a while at least! So Ben goes back to his trusty Autodesk Fusion 360 to make the changes to the design…